MINOLTA-QMS Magicolor 2200 DP Instalační příručka stáhnout pdf (Strana 34)

Plugging in/Turning on the Printer32

Plugging in/Turning on the Printer

Make sure the printer is turned off.

Plug the printer power cord into the

printer and into the dedicated,

grounded, surge-protected electrical

outlet.

WARNING!

Do not overload the outlet. For products installed outside North America, do not connect the

groundwire to gas or water pipes or grounding for telephones.

Turn on the printer.

After a brief warmup, your printer prints a startup page

and displays “

IDLE

” on the message window. If

“

IDLE

” is not displayed in the message window after the

power switch is turned on, the setup operation is not pro-

ceeding correctly or the printer may be malfunctioning.

Recheck the setup. If the startup page doesn’t print or the

print quality is not good, skip ahead to “Troubleshoot-

ing” on page 50.

The printer automatically switches to power-saving mode after 60 minutes of

inactivity. In the Administration/Engine/Energy Saver menu, you can change the

number of minutes before the printer switches to power-saving mode.

In compliance with UL guidelines, “The appliance inlet is considered to be the main

disconnect device.”

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 69 70

Žádné komentáře

MINOLTA-QMS Magicolor 2200 DP Instalační příručka Strana 34